Mitel 5624 Betriebsanweisung PDF herunterladen (Seite 76)

5624 Wireless Handset User Guide

Error or Warning Messages

Display shows Probable cause Action or comment

No access The network is in range but there are

no access rights.

Switch off the handset and then

switch it on again or contact your

system administrator.

No System. The handset

beeps once a minute

(during max 30 minutes)

with a low tone followed

by a high tone (if enabled,

the vibrator also follows

the beeps).

The handset is out of coverage or

handset is defective.

Stop the beep with the Sound off

key and go into range.

Note: When re-entering the

coverage area it can take a couple

of minutes before the handset

automatically registers with the

system.

contact the system administrator.

SERVICE required

Parameters corrupt

Note: This display

message is only shown in

English.

The handset is defective. Select the reset option on the

middle soft key if available. If no

reset option is available or fault

does not resolve the issue the

handset needs repair.

SERVICE required

Invalid IPDI

Note: This display

message is only shown in

English.

Easy replacement procedure not

followed correctly or failure during

easy replacement procedure.

Send the handset for service.

Enter PIN code The handset’s lock is activated. Enter the required PIN code. If the

PIN code is lost enter a new one

via PDM or do a factory reset via

the PDM.

Battery low, charge now The battery level is low. Charge or replace the battery.

Phonebook is not

available at the moment.

The phonebook does not respond, not

available at the moment.

Try again later. If the fault persists

do a factory reset via the Admin

menu or PDM.

Voice mail number not

defined

There is no Voice mail number

defined in the handset.

Define a Voice mail number via the

PDM.

Could not encrypt

connection.

The parameter "Encryption Required"

is enabled in the handset in

combination with;

1. Unencrypted base station(s);

and/or,

2. Unsupported base station(s).

1. Disable the "Encryption

Required" parameter in

handset; and/or,

2. Enable the encryption in the

base station(s); and/or,

Note: If a base station(s) is

used, the software version

must be 3.1.x or later.

3. Use supported base station(s).

Ask your supplier.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

Mitel 5624 Betriebsanweisung Seite 76

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Telefone Mitel 5624