Introduction
This chapter describes the following:
• how to launch Settings and configure advanced settings for the UC360 - see “Launching
Settings” on page 51
• how to configure MCD settings for the UC360 - “MCD Programming for the UC360” on
page 75
Refer to the following documents for more information:
• UC360 Installation Guide for instructions on physically connecting the UC360 Collaboration
Point
• UC360 Engineering Guidelines for information on various configuration settings
Launching Settings
1. Press to display the Menu bar
2. Press Settings
The following screen is displayed:
For the User settings, see “Adjusting Brightness” on page 13 and “Using Clean Mode” on
page 13.
For Advanced settings, see “Advanced Settings” on page 52 on the next page.
Kommentare zu diesen Handbüchern