Mitel SX-50 Bedienungsanleitung PDF herunterladen (Seite 13)

PN: 1725-36137-001_E.doc

Interface Implementation

This section describes the recommended programming to use the

Wireless Telephone System (CPM interface module or SCX-416 MCU)

with a Mitel PBX. The procedures assume:

• The Mitel SX-200, SX-50, or SX-2000 system is installed and

operational in an approved configuration. See the Telephone Switch

Interface Matrix document for tested configurations.

• A trained Mitel technician or system administrator will be on site

with the Installer to program the system.

• The SpectraLink 6000 System or SpectraLink 8000 Telephony

Gateway is installed and the handsets are available for

programming.

Set the Switch Interface Type

SpectraLink 6000 MCU

The SpectraLink 6100 Master Control Unit requires the switch

interface type to be configured using the front panel buttons. The

configuration procedures are detailed in SpectraLink 6100 MCU:

Installation and Operation.

SpectraLink 6300 MCU

When configuring the SpectraLink 6300 MCU, the PBX interfaces are

available as sub-menu selections when defining the Interface Module

type using the SpectraLink 6300 MCU Operator’s Console. Refer to

SpectraLink 6300 MCU: Operator’s Console for details on configuring

the Interface Modules.

SpectraLink 8000 Telephony Gateways

Connect to the SpectraLink 8000 Telephony Gateway using the serial

or modem interface. From the Main Menu, choose Gateway

1 2 ... 8 9 10 11 12 13 14 15 16 17

Keine Kommentare

Mitel SX-50 Bedienungsanleitung Seite 13