
BroadSoft Partner Configuration Guide Mitel SIP Phones June 2007 Document Version 2.0 350 Legget Drive P.O. Box 13089 Kanata, Ontario, Canada K
MITEL SIP PHONES 3.2 Interoperability Issues This section lists the known interoperability issues between BroadWorks and partner release(s). For mor
MITEL SIP PHONES 4 Configuration A Mitel SIP phone can be configured with a configuration file using the Trivial File Transfer Protocol (TFTP) or Hyp
MITEL SIP PHONES 4.1 System Level Configuration This section describes system-wide configuration items that are generally required for each Mitel SI
MITEL SIP PHONES 4.2 Subscriber Level Configuration Parameters This section identifies the device-specific parameters, including registration and au
MITEL SIP PHONES 4.3 Shared Call Appearance Configuration The Shared Call Appearance (SCA) feature allows the administrator to add multiple location
MITEL SIP PHONES 4.3.1 Bob’s Phone Configuration The following steps are used to configure the primary line for Bob’s phone. This line rings when
MITEL SIP PHONES Step Command Purpose Step 3 Enable SIP Authentication. a. In the <user_list> parameter, set the AuthName field (AuthName=&q
MITEL SIP PHONES Step Command Purpose Step 4 Configure the Primary line on Joe's phone. a. In the <pkDescription> parameter, select the
MITEL SIP PHONES 4.3.3 Bob’s Phone Configuration (using the Web Configuration Tool) The following steps are used to configure the primary line for B
MITEL SIP PHONES Step Command Purpose Step 2 Set Register User ID. a. Still in the Add New form of the User List Config, in the User ID or Extensi
MITEL SIP PHONES BroadWorks® Guide Copyright Notice Mitel® and NavigatorTM are registered trademarks of Mitel Networks Corporation. Trademarks Broad
MITEL SIP PHONES Step Command Purpose Step 3 Enable SIP Authentication. a. Still on the User List Config page, in the SIP Authentication User Name
MITEL SIP PHONES Figures 2 and 3 display the configuration files for Bob's and Joe's Mitel 5224 IP phones: Figure 2. Bob's Configurat
MITEL SIP PHONES 5 Enhanced IP Phone Configuration Enhanced IP Phone Configuration is a BroadWorks feature that enables automatic generation of devi
MITEL SIP PHONES Appendix A: Sample Mitel SIP Phone Configuration FilesNOTE: The following samples are examples and should be used as a reference o
MITEL SIP PHONES <other_reason></other_reason> <do_not_disturb>0</do_not_disturb> <noans_fwd_mode>0</noans_
MITEL SIP PHONES <ntfcfg>0</ntfcfg> <lancode>en_CA</lancode> <tonecode>CA</tonecode> <dsmode>1&
MITEL SIP PHONES <pbaddr26></pbaddr26> <pbName27></pbName27> <pbaddr27></pbaddr27> <pbName28>&l
MITEL SIP PHONES <pkDescription> <Key Line="25" Fea="6" Des="Line 1" Addr="" Mode="1&q
MITEL SIP PHONES Group Template File NOTE: This is an example file and should be used for reference only. <Parameter Model="%BWDEVICEID%&quo
MITEL SIP PHONES Appendix B: BroadWorks Validation Package Test Items The following table describes the items tested in each BroadWorks Validation P
MITEL SIP PHONES Document Revision History Version Reason for Change 1.1 Introduced document for Mitel SIP Phones that use SIP Release 6.0 firmware
MITEL SIP PHONES BroadWorks Validation Package Items Supported Session Border Controller Interface Registration Call Origination Call Termination E
MITEL SIP PHONES References [1] Mitel Corporation. 2006. Mitel 5212/5224 SIP User and Administrator Guide. Available from http://edocs.mitel.com/UG/i
MITEL SIP PHONES Table of Contents 1 Overview...
MITEL SIP PHONES Table of Figures Figure 1 Shared Call Appearance Configuration...
MITEL SIP PHONES 1 Overview This document describes the configuration procedures required for the following Mitel SIP Phones to make full use of the
MITEL SIP PHONES 2 BroadWorks Validation Package Support Level Devices are validated according to BroadWorks Validation Packages. Each package vali
MITEL SIP PHONES 3 Device Capabilities and Known Interoperability Issues This section describes the features supported by the Mitel SIP Phones as we
MITEL SIP PHONES Call Forwarding Call Hold Call Hold Ring Back (reminder) Call Logs (Received, Made, Missed) Call Progress Tone Call Reject to voicem
Kommentare zu diesen Handbüchern