Mitel SIP USER AND ADMINISTRATOR GUIDE 5320 Spezifikationen Seite 51

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 61
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 50
5320 SIP Phone SIP User and Administrator Guide
- 45 -
Notes:
An IP phone can have only one DECT Cordless Handset and one DECT Cordless Headset.
A cordless handset or headset can be paired with only one IP phone at a time.
Pairing a new cordless handset or headset with the IP phone overwrites the configuration of
any previous handset or headset
Pairing cannot be performed when the cordless device is already in use.
To pair a DECT cordless accessory:
12. Ensure that the battery of the cordless device to be paired is at least partially charged.
13. Press and hold the pairing button on the back of the Cordless Module (see page
43) for 5
seconds to activate phone pairing mode. The LED on the Cordless Module blinks. The
Cordless Devices application opens on the phone and prompts you to place the accessory in
pairing mode.
14. Press and hold the hookswitch on the side of the cordless handset (see page
47) or headset
(see page
50) for 5 seconds to activate accessory pairing mode. The LED on the cordless
accessory blinks. After a moment, the Cordless Devices application displays protocol,
firmware, hardware, and IPEI information for the device to be paired.
Note: If the LED on the Cordless accessory does not start to blink after 10 seconds, the
accessory requires charging or is still in factory battery saving mode (handset only). Place the
accessory on the charger and charge. The green LED starts to flash indicating that the
accessory is charging. It could take up to 60 minutes for the green LED to start flashing. Allow
the accessory to fully charge, approximately 3 hours.
15. Press Yes to confirm pairing. The Cordless Devices application confirms the pairing by
displaying the paired device name and its battery level indicator.
16. Press Close to exit.
Unpairing an Accessory
To unpair a cordless accessory:
17. Press the blue Menu
key and then press Cordless Devices.
18. Press the device name that you want to unpair. The information screen for the selected
device appears.
19. Press Unpair this Device. If the accessory is in use, an error message is displayed.
Otherwise, the accessory is unpaired, removed from the display, and can no longer be used
to interact with the phone.
20. Press Close.
For more information about the Cordless Devices Application, see page Error! Bookmark not
defined..
Seitenansicht 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare